Welcome, Guest.
Please login or register.
Slide-Out question
Forum Login
Login Name: Create a new account
Password:     Forgot password

BAC Forum    General Boards    Technical Support  ›  Slide-Out question Moderators: Gerald Farris

Slide-Out question  This thread currently has 1,858 views. Print
3 Pages « 1 2 3 All Recommend Thread
Dick Simonis
September 26, 2011, 12:54am Report to Moderator
BAC Member
Posts Per Day: 0.09
Time Online: 5 days 16 hours 29 minutes
Location: Green Valley, AZ
Quoted from Joel Weiss


The owner's manual for my coach clearly states that the rear jacks should be put down first and the coached leveled side to side before putting down the front jack.



Yep, same here.


Dick and Pat

Green Valley, AZ

2000 Beaver Patriot Thunder
Logged Offline
Private Message Reply: 30 - 32
Edward Buker
September 26, 2011, 5:09am Report to Moderator

BAC Member
Posts Per Day: 0.06
Time Online: 22 days 5 hours 33 minutes
One could envision that the normal ride suspension leveling valves being a single design in the front will reach a compromise position without putting any twisting forces on the frame given it will add or subtract air from the four front airsprings uniformly. The rear leveling valves will attempt to offset some amount of side tilt but they are limited in how much compensation they can achieve, especially on the front of the coach, given they are acting on just the rear axle air springs which are all out board. So the coach is fairly uniformly resting on 8 or 10 air springs.

My guess is that the designers felt that the maximum amount of frame twist that could be created was less for the ride suspension leveling valve system due to its configuration than either the full air leveling system or the hydraulic system which has more range of movement and therefor the ability to put more force on one quadrant of the coach frame vs another.
I think it is range of motion for each system that you have to think about and the worst torque on the frame comes when corners are at the extremes of lift and fall range.

The aired up ride suspension I believe would have less range of movement. It is really not about whether you are level or not, it is about how much force and twist was put on the frame to achieve level. Did the required leveling forces distort the slide openings?

I thinco Monaco says aired up resting on 8 or 10 airbags within the range of the over the road leveling system should have limited frame twist enough that the slides will work properly. Most all the problems with body torque seems to occur in the front with windshields popping and large slides rubbing. The front over the road air leveling system does not compensate for side to side offeset at all by design. I'm not the designer but this makes sense to me so I always let the slides out before I dump air and level and always air up before I bring them in.

Later Ed


Ed Buker
Lillian AL
2002 Beaver Marquis
Cat C12
Logged Offline
Private Message Reply: 31 - 32
Ken Buck
September 26, 2011, 3:58pm Report to Moderator
Guest User
Quoted from Joel Weiss


The owner's manual for my coach clearly states that the rear jacks should be put down first and the coached leveled side to side before putting down the front jack.



Just to clarify, the quote to always put the front jack down first is from Diplomat Don, not me. I quoted it exactly as written with a space between paragraphs.

Ken
Logged
E-mail Reply: 32 - 32
3 Pages « 1 2 3 All Recommend Thread
Print

BAC Forum    General Boards    Technical Support  ›  Slide-Out question

Thread Rating
There is currently no rating for this thread